Home > Articles > All Issues > 2021 > Volume 10, No. 6, June 2021 >

Design and Technological Support for the Manufacture of Cardioid Cams of Paper Drilling Machines

Eugene O. Podchasov
Department of Robotics and Complex Automation, Bauman Moscow State Technical University
Department of Theory for Mechanisms and Machines, Mechanical Engineering Research Institute of the Russian
Academy of Sciences, Moscow, Russian Federation

Abstract— Despite the rapid development of information technology and various electronic media, paper remains the main material in the printing industry. Drilling machines plays an important role in such industry, and cardioid cams are significant parts of them. The mechanism for cutting of cardioid cam is studied in paper. Its kinematic is calculated, the equation of trajectory of cutting tool centre is obtained. The problem of calculation of cutting tool edge is considered. The optimization task for creation a mechanism, which produce the most precise trajectory of cutting edge is set. The solution od such a task is offered and optimization criteria are offered.

Index Terms—paper-drilling, cardioid, Limaçon, cam, plasma cutting, machine tool

Cite: Eugene O. Podchasov, "Design and Technological Support for the Manufacture of Cardioid Cams of Paper Drilling Machines," International Journal of Mechanical Engineering and Robotics Research, Vol. 10, No. 6, pp. 308-314, June 2021. DOI: 10.18178/ijmerr.10.6.308-314

​Copyright © 2021 by the authors. This is an open access article distributed under the Creative Commons Attribution License (CC BY-NC-ND 4.0), which permits use, distribution and reproduction in any medium, provided that the article is properly cited, the use is non-commercial and no modifications or adaptations are made.

PREVIOUS PAPER
Computer Aided Definition of the Printing Conditions of Parts Made by FFF
NEXT PAPER
Research on Adjustable K and C Values of Analogous Active Suspension System with Automotive Chip Electronic Control Technology