Volume 7, No. 1, January 2018

General Information

  • ISSN: 2278-0149 (Online)
  • Abbreviated Title:  Int. J. Mech. Eng. Robot. Res.  
  • Editor-in-Chief: ​Prof Richard (Chunhui) Yang, Western Sydney University, Australia
  • Associate Editor: Prof. B.V. Appa Rao, Andhra University; Prof. Ian R. McAndrew, Capitol Technology University, USA
  • Managing Editor: Murali Krishna. B
  • DOI: 10.18178/ijmerr
  • Abstracting/Indexing: Scopus (since 2016), CNKI, Google Scholar, Crossref, etc.
  • E-mail questions to IJMERR Editorial Office.

Submissions

Please send your full manuscript to:

ijmerr@vip.163.com


Useful Documents

Paper Template

Copyright Transfer Agreement

Application For Reviewers

Contact us

International Journal of Mechanical Engineering and Robotics Research
E-mail: ijmerr@vip.163.com

Prediction of Cutting Force in a Circular Peripheral Milling Process

Kamel Mehdi 1,2
1. URMSSDT, Engineering National High School of Tunis (ENSIT), University of Tunis (UT), 5 Avenue Taha Hussein P.B. 56 Bab Mnara 1008 Tunis, Tunisia
2. Preparatory Institute for Engineering Studies El Manar (IPEIEM), University of Tunis EL Manar (UTM), PB. 24, 2092 Tunis, Tunisia

Abstract—This paper presents a two dimensional machining model allowing the simulation of cutting force including the cutting process damping in dynamic circular milling process. The cutting forces obtained through simulation model are compared with experimental results. And a discussion of the effect of various milling parameters on cutting force, such as cutting speed, feed rate, radial depth of cut, tool diameter and tool helix angle, in circular peripheral milling process will be presented. 

Index Terms—cutting force, cutting damping process, circular peripheral milling, numerical simulation.

Cite: Kamel Mehdi, "Prediction of Cutting Force in a Circular Peripheral Milling Process," International Journal of Mechanical Engineering and Robotics Research, Vol. 7, No. 1, pp. 16-21, January 2018. DOI: 10.18178/ijmerr.7.1.16-21