Home > Published Issues > 2016 > Volume 5, No. 4, October 2016 >

Failure Analysis of Hydraulic Rotary Drill Rods in a Limestone Mine

Anirut Chaijaruwanich and Chatchanok Thongthip
Advanced Manufacturing Technology Research Center, Department of Industrial Engineering, Faculty of Engineering, Chiang Mai University, Chiang Mai, Thailand

Abstract—Failure analysis of two hydraulic rotary drills used for rock drilling was carried out. Chemical analysis, metallurgical examination, surface fractography and hardness measurement were used for the analysis. The failed drill rods composition matched with low alloy 31NiCrMo13-4 grade steel. The hardness measurement results suggested that the drilled rods were surface hardened. Surface fractography examination revealed that crack initiation of the fractured drill rods started at the outer surface, especially at the joint between the drill rod and drill bit. The mode of failure was found to be fatigue. The stress concentration locating at groove of threads at the joint was likely to cause the crack initiation. Propagation of fracture was observed with the evidence of beach mark, resulting from continuous nominal low stress.
 
Index Terms—Failure analysis, surface fractography, fatigue, rotary drill, low alloy steel

Cite: Anirut Chaijaruwanich and Chatchanok Thongthip, "Failure Analysis of Hydraulic Rotary Drill Rods in a Limestone Mine," International Journal of Mechanical Engineering and Robotics Research, Vol. 5, No. 4, 251-254, October 2016. DOI: 10.18178/ijmerr.5.4.251-254